M4 Single Point Harness

Watch Informational Video About the M4 Harness

This is a one of a kind item that you won't find anywhere else. This patented single point shoulder harness was designed for performance and will outperform all other slings or harnesses on the market. It has several features that are unique and separate it from the competition.

1. Quick disconnect that allows the operator to attach or disconnect the rifle with ease, even with gloves.
2. Locking disconnect allows the operator to lock the connector so the rifle won't ever mistakenly be dropped if the connector gets bumped.
3. A medium width 1" smooth nylon-web strap that allows the operator to slide the strap on the body to get the rifle to your back, freeing up your hands and the front of your body.
4. Non-elastic band which is a must for running (you don't want the rifle bouncing and beating you up while running) and helping the operator properly position the rifle while transitioning to the prone position. The strap can be adjusted for optimum play, allowing the operator to shoot from either shoulder without making any adjustments.
5. A clever fiber reinforced Nylon coupler attaches directly to tube of the M4's collapsible stock
6. Available in either black or flat dark earth colors

Quick Release M-4 Single Point Rifle Harness

Quick Release Operation

Rotate collar housing to the unlocked position and pull release collar back.

Pull quick release plug from socket.

Quick Release Harness System Disconnected

1. Thread the supplied nylon cord through one side and out the top of the Plug.

2. Thread the un-knotted end of the cord through the Quick-Attach Sling Mount or End-Plate Sling Mount.

3. Thread the end of the cord back through the end and out the other side of the Plug.

4. Pull the un-knotted end of the cord until the Quick Release Harness Plug is drawn close to the Sling Mount. The knot should pull inside of the plug.

5. Tie a simple, single-loop knot, similar to the knot on the other end of the cord, as close to the Plug as possible. Ensure the knot is tight, then cut the excess cord. Using a lighter or match, briefly (about 1 second) touch the knot and cut end with a flame to slightly melt the cord and seal the knot. Then pull on the Quick Release Harness Plug until the new knot is drawn up into the Plug.

Dimensions

Material:Glass filled Nylon, Stainless Steel (springs, and retainer clip)

Installing the quick-attach sling mount

Depress telestock latch fully and slide telestock off of receiver extension.

Slide locking insert into the sling mount clamp and push onto receiver extension unit.

Install #6 Screw and tighten until snug.